No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Synchronization Between LDP and IGP

Verifying the Configuration of Synchronization Between LDP and IGP

Prerequisites

The configurations of the synchronization between LDP and IGP function are complete.

Procedure

  • Run the display ospf ldp-sync interface { all | interface-type interface-number } command to check information about synchronization between LDP and OSPF on an interface.
  • Run the display isis [ process-id ] ldp-sync interface command to check information about synchronization between LDP and IS-IS on the interface.
  • Run the display rm interface [ interface-type interface-number | vpn-instance vpn-instance-name ] command to check information about the route management.
Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 122390

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next