No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the CR-LSP Backup Configuration

Verifying the CR-LSP Backup Configuration


The configurations of CR-LSP backup are complete.


  • Run the display mpls te tunnel-interface [ tunnel tunnel-number ] command to check information about the tunnel interface.
  • Run the display mpls te hot-standby state { all [ verbose ] | interface tunnel interface-number } command to check information about the hot-standby status.
  • Run the display mpls te tunnel [ destination ip-address ] [ lsp-id ingress-lsr-id session-id local-lsp-id ] [ lsr-role { all | egress | ingress | remote | transit } ] [ name tunnel-name ] [ { incoming-interface | interface | outgoing-interface } interface-type interface-number ] [ verbose ] command to check CR-LSP information.
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 129545

Downloads: 91

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next