No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MPLS TE and RSVP-TE

Enabling MPLS TE and RSVP-TE


To create a dynamic MPLS TE tunnel, first enable MPLS TE, enable RSVP-TE globally, enable RSVP-TE on an interface, and perform other configurations, such as setting the link bandwidth attributes and enabling CSPF.

Perform the following configurations on each node of the MPLS TE tunnel.


  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls te

    MPLS TE is enabled on the node globally.

  4. Run mpls rsvp-te

    RSVP-TE is enabled on the node.

  5. Run quit

    The system view is displayed.

  6. Run interface interface-type interface-number

    The MPLS TE interface view is displayed.

  7. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  8. Run mpls

    The MPLS is enabled on the interface.

  9. Run mpls te

    The MPLS TE is enabled on the interface.

  10. Run mpls rsvp-te

    RSVP-TE is enabled on the interface.

Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 122149

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next