No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying Connectivity and Reachability of Seamless MPLS Networks

Verifying Connectivity and Reachability of Seamless MPLS Networks

Context

Run the following commands in any view of a BGP LSP endpoint node to check the connectivity and reachability of a BGP LSP.

Procedure

  • Run the ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m interval | -r reply-mode | -s packet-size | -t time-out | -v ] * bgp destination-address mask-length [ ip-address ] command to check BGP LSP connectivity.
  • Run the tracert lsp [ -a source-ip | -exp exp-value | -h ttl-value | -r reply-mode | -t time-out ] * bgp destination-address mask-length [ ip-address ] command to perform an LSP tracert operation on a BGP LSP.
Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 118409

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next