No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling BFD Globally

Enabling BFD Globally

Context

To configure static BFD for TE, enable BFD globally on the ingress and egress nodes of a tunnel.

Perform the following configurations on the ingress and egress nodes of an MPLS TE tunnel.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bfd

    BFD is enabled globally.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 117576

Downloads: 88

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next