No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LDP Extensions for Inter-Area LSPs

Configuring LDP Extensions for Inter-Area LSPs

Pre-configuration Tasks

Before configuring LDP extensions for inter-area LSPs, complete the following tasks:

  • Configure a local LDP session. For details, see Configuring Basic Functions of MPLS LDP.

  • Configure a policy for summarizing routes. For details, see S7700 and S9700 V200R011C10 Configuration Guide - IP Unicast Routing.

LDP extensions for inter-area LSPs enable LDP to search for routes according to the longest match rule and use summarized routes to establish LDP LSPs spanning multiple IGP areas.

Context

Perform the following steps on the ingress or transit node.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls ldp

    The MPLS LDP view is displayed.

  3. Run longest-match

    LDP is configured to search for routes based on the longest match rule to establish LSPs.

    By default, LDP searches for routes to establish LSPs based on the exact matching rule.

    NOTE:

    Configuring this command during LDP GR is not allowed.

Verifying the Configuration

Run the display mpls lsp command to check the setup of inter-area LSPs after LDP is configured to search for routes based on the longest match rule to establish LSPs.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 117776

Downloads: 88

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next