No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for MPLS TE

Default Settings for MPLS TE

Table 5-26  Default settings for MPLS TE
Parameter Default Setting
MPLS TE Disabled
RSVP TE Disabled
Metric type in path selection for tunnels TE
Affinity property of tunnels The values of affinity property and mask are both 0x0.
Maximum reservable link bandwidth 0
Tunnel priority The values of setup priority and hold priority are both 7.
Route and label storing Disabled
Route pinning Disabled
Waiting period from a TE tunnel going Down to the network informed of the change 0
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 122151

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next