No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Inter-Area LSP Fails to Be Established

Inter-Area LSP Fails to Be Established

Fault Description

An inter-area LSP fails to be established after LDP extension for inter-area LSP is configured.

Procedure

  1. Check whether LDP extension for inter-area LSP is configured.

    Run the display mpls ldp command to check the displayed Longest-match field. If the field is displayed as On, LDP extension for inter-area LSP is enabled. If the field is displayed as Off, LDP extension for inter-area LSP is disabled.

    • If LDP extension for inter-area LSP is disabled, run the longest-match command to enable this function.

  2. Check whether the LDP session is correctly established.

    Run the display mpls ldp session command to check the displayed Status field. If LDP session status is Operational, the LDP session is established and in Up state. If LDP session status is not Operational or no LDP session information is displayed, the LDP session is not established.

  3. Check whether the LDP session matches the route.

    Run the display ip routing-table command to check the fields NextHop and Interface.

    Run the display mpls ldp session verbose command to check the Addresses received from peer field.

    Run the display mpls ldp peer command to check the DiscoverySource field.

    If the field NextHop is contained in the field Addresses received from peer and the values of fields Interface and DiscoverySource are the same, the LDP session matches the route.

    • If the LDP session does not match the route, locate the fault by referring to LDP LSP Is Down.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 122421

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next