No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD to Detect an LDP LSP

Configuring Static BFD to Detect an LDP LSP


When static BFD monitors an LDP LSP, pay attention to the following points:
  • BFD is bound to only the ingress node of an LDP LSP.

  • One LSP is bound to only one BFD session.

  • The detection only supports the LDP LSP that is triggered to establish by the host route.

  • The forwarding modes on the forwarding path and reverse path can be different (for example, an IP packet is sent from the source to the destination through an LSP, and is sent from the destination to the source in IP forwarding mode), but the forwarding path and reverse path must be established over the same link. If they use different links, BFD cannot identify the faulty path when a fault is detected.

Static BFD for LDP LSPs fast detects faults on an LDP LSP. Static BFD for LDP LSPs can be flexibly deployed, but needs to be manually controlled.

Pre-configuration Tasks

Before configuring static BFD to detect an LDP LSP, configure a local LDP session. For details, see Configuring Basic Functions of MPLS LDP.

Configuration Procedure

Configure static BFD for LDP LSPs according to the following sequence.

Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 130251

Downloads: 91

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next