No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring AGG as the RR

Configuring AGG as the RR


On an inter-AS seamless MPLS network, configuring an AGG as a reflector and specifying a CSG and an AGG ASBR as the AGG's clients enable the AGG to transmit loopback routes from the CSG to the AGG ASBR. The AGG then transmits the routes to the core layer through an EBGP peer. The loopback routes can be used to set up an MP-EBGP peer relationship between the CSG and MASG.


  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run ipv4-family unicast

    The IPv4 unicast address family view is displayed.

  4. Run peer { ipv4-address | group-name } reflect-client

    An RR is configured, and the CSG and core ASBR are specified as clients.

    By default, no RR or specified client is configured for BGP.

  5. Run peer { ipv4-address | group-name } next-hop-local

    The device is configured to use its own IP address as the next-hop address of routes when advertising these routes.

    By default, when BGP advertises routes to an EBGP peer, it uses its own IP address as the next hops. When BGP advertises routes to an IBGP peer, it does not change the next hop attribute.

    To enable the AGG to advertise routes with the next hop address set to a local address, run the peer next-hop-local command on the AGG.

Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 119379

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next