No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating a DiffServ Domain and Configuring Priority Mapping

Creating a DiffServ Domain and Configuring Priority Mapping


A DiffServ domain comprises of connected DiffServ nodes, which use the same service policy and implement the same PHBs.

When traffic enters a device, the device maps packet priorities to PHBs and colors. The device performs congestion management based on PHBs and congestion avoidance based on colors. When traffic flows out of the device, the device maps PHBs and colors of packets to priorities. The downstream device provides QoS services based on packet priorities.


  1. Run system-view

    The system view is displayed.

  2. Run diffserv domain { default | ds-domain-name }

    A DiffServ domain is created and the DiffServ domain view is displayed.

    The default domain defines the default mappings from packet priorities to PHBs and colors. You can modify the mappings defined in the default domain but cannot delete the default domain.

  3. Define a traffic policy on the device.

    • Run mpls-exp-inbound exp-value phb service-class [ color ]

      The inbound interface is configured to map EXP priorities of MPLS packets to the PHBs and colors.

    • Run mpls-exp-outbound service-class color map exp-value

      The outbound interface is configured to map PHBs and colors to EXP priorities of MPLS packets.

    To check the default mappings between PHBs and colors of MPLS packets and EXP priorities, see mpls-exp-inbound and mpls-exp-outbound commands.

Verifying the Configuration

Run the display diffserv domain [ all | name ds-domain-name ] command to check the DiffServ domain configuration.

Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 129548

Downloads: 91

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next