No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling a Device from Distributing Labels to Remote Peers

(Optional) Disabling a Device from Distributing Labels to Remote Peers

Context

In MPLS L2VPN scenarios using LDP (including Martini VLL, PWE3, and Martini VPLS), PEs at both ends need to establish a remote LDP session. The remote LDP session is only used to transmit Label Mapping messages, so LDP is not required. By default, LDP allocates common LDP labels to remote peers. Many useless idle labels are generated, wasting LDP labels.

To solve the preceding problem, disable a device from distributing labels to remote peers to save system resources. You can use either of the following modes:

  • In the LDP view, disable the PE from distributing labels to all remote peers.

  • In the view of a specified remote peer, disable the PE from distributing labels to the specified remote peer.

Procedure

  • Disable a device from distributing labels to a specified remote peer.
    1. Run system-view

      The system view is displayed.

    2. Run mpls ldp remote-peer remote-peer-name

      The remote MPLS LDP peer view is displayed.

    3. Run remote-ip ip-address pwe3

      LDP is prevented from allocating public network labels to a specified remote peer device.

      By default, the IP address of the remote LDP peer is not configured.

  • Disable a device from distributing LDP labels to all remote peers.
    1. Run system-view

      The system view is displayed.

    2. Run mpls ldp

      The MPLS LDP view is displayed.

    3. Run remote-peer pwe3

      LDP is prevented from allocating public network labels to all remote peer devices.

      By default, an LSR is permitted to distribute public network labels to all remote peers.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 118427

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next