No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic Functions of MPLS LDP

Configuring Basic Functions of MPLS LDP

You can build an MPLS network only after basic functions of MPLS LDP are configured.

Pre-configuration Tasks

Before configuring basic functions of MPLS LDP, configure static routes or an IGP to ensure that IP routes between LSRs are reachable.


When Routing Information Protocol version 1 (RIP-1) is used, you need to enable LDP to search for routes to establish LSPs according to the longest match rule. For details, see Configuring LDP Extensions for Inter-Area LSPs.

Configuration Procedure

Configure basic functions of MPLS LDP according to the following sequence.

Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 117587

Downloads: 88

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next