No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LDP LSP Is Down

LDP LSP Is Down

Fault Description

An LDP LSP is Down after being established.

Procedure

  1. Check whether the LDP session is correctly established.

    Run the display mpls ldp session command to check the displayed Status field. If LDP session status is Operational, the LDP session is established and in Up state. If LDP session status is not Operational, the LDP session is not established.

    • If the LDP session is not established, rectify the fault by referring to LDP Session Is Down.

  2. Check whether the LSP establishment policy is configured.

    • Run the display this command in the MPLS view. If information similar to the following is displayed:
      lsp-trigger ip-prefix abc
      Check whether the Down LSP is filtered out based on the IP prefix list abc.
    • Run the display this command in the MPLS-LDP view. If information similar to the following is displayed:
      propagate mapping for ip-prefix abc
      Check whether the Down LSP is filtered out based on the IP prefix list abc.
    • Run the display ip ip-prefix command in the system view. If information similar to the following is displayed:
             index: 10               permit  10.1.1.1/32
             index: 20               permit  10.2.2.2/32
      The LSP can be established only based on routes 10.1.1.1/32 and 10.2.2.2/32.

    • If the preceding IP prefix list is configured, add routing information of the Down LSP to the IP prefix list.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 123457

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next