No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Importing Traffic to an MPLS TE Tunnel

Importing Traffic to an MPLS TE Tunnel

An MPLS TE tunnel does not automatically direct traffic. To enable traffic to travel along an MPLS TE tunnel, you need to use some method to direct traffic to the MPLS TE tunnel.

Pre-configuration Tasks

Before importing traffic to the MPLS TE tunnel, complete one of the following tasks:

Configuration Procedure

To direct traffic to the MPLS TE tunnel, perform one of the following operations according to the network planning. You are advised to use the auto route mechanism.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 122580

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next