No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Dynamic BFD for CR-LSPs

Verifying the Configuration of Dynamic BFD for CR-LSPs

Prerequisites

The configurations of dynamic BFD for CR-LSPs are complete.

Procedure

  • Run the display bfd configuration dynamic [ verbose ] command to check the configuration of dynamic BFD on the ingress.
  • Run the display bfd configuration passive-dynamic [ peer-ip peer-ip remote-discriminator discriminator ] [ verbose ] command to check the configuration of dynamic BFD on the egress.
  • Run the display bfd session dynamic [ verbose ] command to check information about the BFD session on the ingress.
  • Run the display bfd session passive-dynamic [ peer-ip peer-ip remote-discriminator remote-discr-value ] [ verbose ] command to check information about the BFD session passively created on the egress.
  • Check the BFD statistics.

    • Run the display bfd statistics command to check statistics about all BFD sessions.
    • Run the display bfd statistics session dynamic command to check statistics about dynamic BFD sessions.

  • Run the display mpls bfd session [ fec fec-address | monitor | nexthop ip-address | outgoing-interface interface-type interface-number | statistics | verbose ] or display mpls bfd session protocol { cr-static | rsvp-te } [ lsp-id ingress-lsr-id session-id lsp-id [ verbose ] ] command to check information about BFD sessions.
Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 122150

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next