No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Synchronization Between LDP and IGP

Configuring Synchronization Between LDP and IGP

Synchronization between LDP and IGP applies to MPLS networks where primary and backup LSPs exist. LSPs are established between LSRs based on IGP. When the LDP session on the primary LSP fails (not due to a link failure) or the faulty primary LSP is restored, you can enable synchronization between LDP and IGP to prevent traffic interruption caused by the active/standby switchover.

Pre-configuration Tasks

Before configuring synchronization between LDP and IGP, configure a local LDP session. For details, see Configuring Basic Functions of MPLS LDP.

Configuration Procedure

Enabling synchronization between LDP and IGP is mandatory and other tasks are optional.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 119767

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next