No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling Auto TE FRR

Enabling Auto TE FRR


Before configuring auto TE FRR, enable auto TE FRR globally on the PLR. To implement link protection, enable link protection on an interface.

Perform the following configurations on the PLR.


  1. Run system-view

    The system view is displayed.

  2. Run mpls

    The MPLS view is displayed.

  3. Run mpls te auto-frr

    Auto TE FRR is enabled globally.

    After auto TE FRR is enabled globally, link protection is enabled on all interfaces enabled with MPLS TE.

  4. (Optional) Configure MPLS TE Auto FRR in the interface view.
    1. Run quit

      Return to the system view.

    2. Run interface interface-type interface-number

      The interface view of the outbound interface of the primary tunnel is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run mpls te auto-frr { link | node | default }

      Auto TE FRR is enabled on the outbound interface on the ingress node of the primary tunnel.

      To implement link protection, specify link. If link is not specified, the system provides only node protection.

      By default, after auto TE FRR is enabled globally, all the MPLS TE interfaces are automatically configured with the mpls te auto-frr default command. To disable auto TE FRR on some interfaces, run the mpls te auto-frr block command on these interfaces. Then, these interfaces no longer have auto TE FRR capability even if auto TE FRR is enabled or is to be re-enabled globally.


      After mpls te auto-frr is used in the MPLS view, the mpls te auto-frr default or mpls te auto-frr node command used on an interface protects only nodes. When the topology does not meet the requirement to set up an automatic bypass tunnel for node protection, the penultimate hop (but not other hops) on the primary tunnel attempts to set up an automatic bypass tunnel for link protection.

Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 119080

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next