Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring CR-LSP Backup
CR-LSP backup provides an end-to-end protection mechanism. If a primary CR-LSP fails, traffic rapidly switches to a backup CR-LSP, ensuring uninterrupted traffic transmission.
Pre-configuration Tasks
Before configuring CR-LSP backup, complete the following tasks:![]()
NOTE:
- Configure a dynamic MPLS TE or DS-TE tunnel. For details, see Configuring a Dynamic MPLS TE Tunnel.
- Enable MPLS, MPLS TE, and RSVP-TE globally and on interfaces of each node along a backup CR-LSP.
NOTE: If CR-LSP hot standby is configured, perform the operation of Configuring Static BFD for CR-LSPs or Configuring Dynamic BFD for CR-LSPs to implement fast switching at the millisecond level.
Previous
