No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling TE FRR

Enabling TE FRR


TE FRR must be enabled for a primary tunnel before a bypass tunnel is established.

Perform the following configurations on the ingress node of an MPLS TE tunnel.


  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel tunnel-number

    The interface view of a primary tunnel is displayed.

  3. Run mpls te fast-reroute [ bandwidth ]

    TE FRR is enabled.


    Only the primary tunnel in a tunnel protection group can be configured together with TE FRR on the ingress node. Neither the protection tunnel nor the tunnel protection group itself can be used together with TE FRR. If the tunnel protection group and TE FRR are used, neither of them takes effect.

    For example, Tunnel1 and Tunnel2 are tunnel interfaces on MPLS TE tunnels and the tunnel named Tunnel2 has a tunnel ID of 200. The mpls te protection tunnel 200 and mpls te fast-reroute commands cannot be configured simultaneously on Tunnel1. That is, the tunnel protection group and TE FRR cannot be used together on Tunnel1. A configuration failure will occur if the mpls te protection tunnel 200 command is run on Tunnel1 and the mpls te fast-reroute command is run on Tunnel2.

  4. Run mpls te commit

    The configuration is committed.

Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 119350

Downloads: 89

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next