No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S7700 and S9700 V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Defense Against TCP SYN Flood Attacks

Configuring Defense Against TCP SYN Flood Attacks

Context

An attacker sends a SYN packet to a target host to initiate a TCP connection but does not respond to the SYN+ACK sent from the target host. If the target host does not receive an ACK packet from the attacker, it keeps waiting for the ACK packet. Therefore, a half-open connection is formed. If the attacker keeps sending SYN packets, the target host sets up a large number of half-open connections, thus wasting resources.

To prevent TCP SYN flood attacks, enable defense against TCP SYN flood attacks and set the rate limit for TCP SYN flood attack packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run anti-attack tcp-syn enable

    Defense against TCP SYN flood attacks is enabled.

    By default, defense against TCP SYN flood attacks is enabled.

    NOTE:
    You can also run the anti-attack enable command in the system view to enable attack defense against all attack packets including malformed packets.

  3. Run anti-attack tcp-syn car cir cir

    The rate limit at which TCP SYN packets are received is set.

    By default, the rate limit at which TCP SYN packets are received is 155000000 bit/s.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178319

Views: 146132

Downloads: 79

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next