No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Security

S7700 and S9700 V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Service Is Abnormal Because the Upstream Interface Is Not Configured as a Trusted Interface

Service Is Abnormal Because the Upstream Interface Is Not Configured as a Trusted Interface

Fault Description

After IPSG is enabled in a VLAN, the hosts in the VLAN cannot access the Internet. Service on the hosts is abnormal.


  1. Check whether the upstream interface belongs to the VLAN with IPSG enabled.

    If the upstream interface belongs to the VLAN, configure this interface as the trusted interface; otherwise, the return packets are discarded because they do not match the binding entries. As a result, user service is interrupted.

    In Figure 12-17, Host_1 and Host_2 belong to VLAN 10. IF3 allows the packets of VLAN 10 to pass. The static binding entries are configured on the switch for Host_1 and Host_2, and IPSG is enabled in VLAN 10. The hosts can communicate with each other, but cannot access the Internet. Host_1 is used as an example here to describe the fault symptom:
    • Host_1 sends a packet to the Internet. When the packet reaches IF1 of the switch, the switch detects that the packet matches a binding entry, and forwards it.
    • A packet is sent from the Internet to Host_1. When the packet reaches IF3, which belongs to VLAN 10, the switch detects that the packet does not match any binding entry, and discards the packet.
    Figure 12-17  Service is abnormal because the upstream interface is not configured as a trusted interface

  2. Perform the following operations:
    1. Run the system-view command to enter the system view.
    2. Run the dhcp enable command to enable DHCP globally.
    3. Run the dhcp snooping enable command to enable DHCP snooping globally.
    4. Run the interface interface-type interface-number command to enter the IF3 interface view.
    5. Run the dhcp snooping trusted command to configure IF3 as a trusted interface.
Updated: 2019-04-01

Document ID: EDOC1000178319

Views: 146298

Downloads: 79

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next