No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S7700 and S9700 V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Understanding Storm Control

Understanding Storm Control

Storm control prevents broadcast storms caused by broadcast packets, unknown multicast packets, and unknown unicast packets. It is configured in the interface view to limit the number of packets per second.

In a detection interval, a switch with storm control configured monitors the average rates of incoming packets on an interface and compares the average rates with the thresholds. When the rate of a particular type of packets exceeds the threshold allowed for these packets, the switch takes a storm control action on the interface.

Storm control actions include block and shutdown. An interface that is blocked or shut down can be recovered in the following ways:
  • When the average rates of incoming packets on a blocked interface fall below the lower thresholds, the interface is unblocked to forward packets.
  • If the action is shutdown, manually unblock the interface or enable the interface to automatically recover to the Up state.
NOTE:

When detecting unicast packets, a switch does not distinguish unknown unicast packets from known unicast packets. The packet rate detected is the sum of the rates of unknown and known unicast packets. When the storm control action is block, the switch blocks only the unknown unicast packets. This rule also applies to multicast packets.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178319

Views: 141747

Downloads: 78

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next