No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S7700 and S9700 V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for URPF

Licensing Requirements and Limitations for URPF

Involved Network Elements

Other network elements are not required.

Licensing Requirements

Unicast Reverse Path Forwarding (URPF) is a basic feature of a switch and is not under license control.

Version Requirements

Table 14-1  Products and versions supporting URPF

Product

Product Model

Software Version

S7700

S7703, S7706, S7712

V100R003C01, V100R006C00, V200R001(C00&C01), V200R002C00, V200R003C00, V200R005C00, V200R006C00, V200R007C00, V200R008C00, V200R009C00, V200R010C00, V200R011C10

S9700

S9703, S9706, S9712

V200R001(C00&C01), V200R002C00, V200R003C00, V200R005C00, V200R006C00, V200R007(C00&C10), V200R008C00, V200R009C00, V200R010C00, V200R011C10

NOTE:
To know details about software mappings, see Hardware Query Tool.

Feature Limitations

  • URPF checks IPv4 and IPv6 packets but does not check the following packets:
    • BOOTP, DHCP, and DHCPv6 packets
    • Packets with the source port number 67 and destination port number 68
    • Packets with the source port number 68 and destination port number 67
  • For cards except for X series cards, the number of FIB entries are reduced by half if URPF is enabled. You are advised to enable URPF before services are deployed. If you need to enable URPF after services are deployed, configure URPF when less traffic is transmitted and ensure that network requirements are met if the number of FIB entries is reduced by half. For EC series cards, ED series cards, and EE series cards, you can run the assign resource-mode slot slot-id mode enhanced-ipv4 command to expand their FIB entries.
Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178319

Views: 137016

Downloads: 78

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next