No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Security

S7700 and S9700 V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Defense Against DHCP Server DoS Attacks

Defense Against DHCP Server DoS Attacks


In Figure 9-7, if a large number of attackers request IP addresses on if1, IP addresses in the IP address pool are exhausted. This results in no IP addresses being available for authorized users.

A DHCP server identifies the MAC address of a client based on the client hardware address (CHADDR) field in the DHCP Request message. If an attacker continuously applies for IP addresses by changing the value of the CHADDR field, IP addresses in the address pool on the DHCP server may be exhausted. As a result, authorized users cannot obtain IP addresses.

Figure 9-7  Defense against DHCP server DoS attacks


To prevent DHCP server DoS attacks, enable DHCP snooping on the device and then set the maximum number of access DHCP clients allowed on the device or an interface. Only the allowed number of DHCP clients can obtain an IP address through the device or interface.

You can enable the device to check whether the MAC address in the Ethernet frame header matches the value of the CHADDR field in the DHCP message. If the two values match, the message is forwarded. Otherwise, the message is discarded.

Updated: 2019-04-01

Document ID: EDOC1000178319

Views: 145889

Downloads: 78

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next