No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Security

S7700 and S9700 V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Aging Time of Temporary ARP Entries

Configuring the Aging Time of Temporary ARP Entries


In addition to generating ARP Miss messages, the device generates temporary ARP entries and sends ARP Request packets to the destination network.
  • In the aging time of temporary ARP entries:
    • Before receiving an ARP reply packet, the device discards the IP packets matching the temporary ARP entry and does not generate ARP Miss messages.
    • After receiving an ARP Reply packet, the device generates a correct ARP entry to replace the temporary entry.
  • When temporary ARP entries age out, the device clears them. If no ARP entry matches the IP packets forwarded by the device, ARP Miss messages and temporary ARP entries are repeatedly generated.

You can limit the rate of ARP Miss messages by setting the aging time of temporary ARP entries. When a device undergoes an ARP Miss attack, you can extend the aging time of temporary ARP entries to reduce the frequency of triggering ARP Miss messages so that the impact on the device is minimized.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run arp-fake expire-time expire-time

    The aging time of temporary ARP entries is set.

    By default, the aging time of temporary ARP entries is 3 seconds.

Updated: 2019-10-18

Document ID: EDOC1000178319

Views: 151481

Downloads: 84

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next