No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S7700 and S9700 V200R011C10

This document describes the configurations of Security, including ACL, reflective ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the User-Level Rate Limiting

Enabling the User-Level Rate Limiting

Context

User-side hosts are prone to virus attacks. Infected hosts may send a large number of protocol packets to network devices, causing a high CPU usage and degraded performance on the devices and affecting services. You can configure the user-level rate limiting to resolve this problem. User-level rate limiting identifies users by user MAC addresses and limits the rates of specified packets (ARP, ND, DHCP Request, DHCPv6 Request, IGMP, 802.1X, and HTTPS-SYN packets) for both wired and wireless users. By default, the threshold for each user MAC address is 10 pps.

The user-level rate limiting is more precise than CPCAR (based on card) and port attack defense (based on interface) because it is user-specific and has little impact on online users.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run cpu-defend host-car enable

    The user-level rate limiting is enabled.

    By default, the user-level rate limiting is enabled.

Translation
Download
Updated: 2019-09-23

Document ID: EDOC1000178319

Views: 149949

Downloads: 82

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next