No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Web-based Configuration Guide

S7700 and S9700 V200R011C10

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Configuring SNMP

Example for Configuring SNMP

Networking Requirements

An enterprise has purchased a new switch. To manage the switch using the NMS on the live network, the administrator needs to configure the SNMP service on the switch. The network shown in Figure 10-6 is secure but has heavy service traffic, so the administrator configures SNMPv2c to implement communication between the NMS and managed devices.

Figure 10-6  Configuring SNMPv2c to implement communication between the NMS and switch

Configuration Description

Before configuring SNMP, complete the following tasks:

  • Ensure that a reachable route exists between the switch and NMS. The configuration procedure is not provided.
  • Configure SNMPv2c on the switch to be managed by the NMS running SNMPv2c.
  • Configure a community name based on which the switch authenticates the NMS.
  • Configure the NMS according to the NMS manual so that the NMS can manage SNMP-enabled switch. The configuration procedure is not provided.


  1. Click Maintenance to open the maintenance page.
  2. Click System Maintenance > SNMP in the navigation tree to open the SNMP configuration page, as shown in Figure 10-7.

    Set the parameters as follows:

    • Select ON for SNMP.
    • Set Version number to v2c.
    • Fill adminnms01 into Community name.
    • Fill adminnms01 into Confirm community name.
    Figure 10-7  SNMP configuration

  3. Click Apply
  4. Click in the function area and click OK in the displayed dialog box to save the SNMP configuration.


Perform the following operations on the NMS according to the NMS manual: set the SNMP version to SNMPv2c, set the read/write community name to adminnms01, and set the SNMP connection port number to 161 (default port used by the switch).

After the preceding configurations are complete, the NMS can manage the switch.

Updated: 2019-10-17

Document ID: EDOC1000178323

Views: 92974

Downloads: 123

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next