No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Web-based Configuration Guide

S7700 and S9700 V200R011C10

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SVF Enabling

SVF Enabling

This section describes how to configure a switch as the parent in an SVF system.

Procedure

  1. Choose Configuration > SVF Quick Config > SVF Enabling. The SVF Enabling page is displayed.
  2. Set Enable SVF to ON. The SVF Enabling page is displayed, as shown in Figure 5-1.

    Figure 5-1  SVF Enabling page

    Table 5-1 describes the parameters on the page.
    Table 5-1  Parameters on the SVF Enabling page

    Item

    Description

    Enable SVF

    Indicates whether to enable SVF on the parent:
    • ON: Enable SVF on the parent.
    • OFF: Disable SVF on the parent.

    Basic SVF Configuration

    Management VLAN ID

    Configures a management VLAN. The value defaults to 4090 and cannot be VLAN 1 or VLAN 4093.

    Management network scale

    Specifies the total number of ASs and APs. A value slightly larger than the actual value is recommended for capacity expansion.

    Management IP address/mask

    Configures a management IP address.

    AS access authentication

    Indicates whether to authenticate an AS when it attempts to connect to an SVF system:
    • ON: The AS needs to be authenticated.
    • OFF: The AS does not need to be authenticated.

    AP access authentication

    Configures the AP authentication mode:
    • Non-authentication
    • MAC address authentication
    • SN authentication

    Advance SVF Configuration

    AS forwarding mode

    Configures the forwarding mode:
    • Distributed: Local traffic of an AS is directly forwarded from the AS, and traffic between ASs is sent to the parent for forwarding.
    • Centralized: Both traffic forwarded by the local AS and traffic forwarded between ASs are sent to the parent for forwarding.

    Administrator in Independent Configuration Mode

    Creates the administrator and sets the password for AS login in independent configuration mode.

  3. Configure the parameters.
  4. Click Apply.
  5. In the dialog box that is displayed, click OK.
Translation
Download
Updated: 2019-10-17

Document ID: EDOC1000178323

Views: 83828

Downloads: 112

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next