Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ACL Reference
This section describes how to reference ACLs.
This node is only available in the NAC unified mode.
Interface ACL
Procedure
- Choose Interface ACL tab, as shown in Figure 5-136. and click the
- Select a port to be configured. Perform the
following operations as required in the port area:
- Click a port icon. To deselect the port, click the port icon again.
- Drag the cursor to select consecutive ports in a batch.
- Click multiple port icons to select these ports, and click a port icon again to deselect the port.
- Select a slot where an LPU is located. All ports on the LPU are selected.
- Configure the inbound and outbound ACL numbers.
- After setting the parameters, click Apply.
VLAN ACL
Procedure
- Choose VLAN ACL tab, as shown in Figure 5-138. and click the
- Click
next to VLAN ID to select VLAN ID.
- Configure the inbound and outbound VLAN ACL numbers.
- After setting the parameters, click Apply.