No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Web-based Configuration Guide

S7700 and S9700 V200R011C10

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LBDT

LBDT

This section describes how to configure LBDT.

Context

When a loop occurs on a network, broadcast, multicast, and unknown unicast packets are repeatedly transmitted on the network. This wastes network resources or even causes service interruption on the entire network. To allow the device to detect loops on a Layer 2 network in a timely manner and prevent the network from being severely affected by loops, configure loopback detection. Loopback detection enables the device to periodically send loopback detection packets to detect loops. When a loop is detected on an interface, the device shuts down or blocks the interface to eliminate the loop. The interface can be restored when the device detects that the loop on the interface is eliminated.

Procedure

  1. Click Configuration in the function area and choose Advanced Services > LBDT from the navigation tree in the left. The LBDT page is displayed, as shown in Figure 5-104.

    Figure 5-104  Loopback detection configuration page

    Table 5-55 describes parameters on the loopback detection configuration page.

    Table 5-55  Parameters on the loopback detection configuration page

    Parameter

    Description

    Enable (Block Interface)

    Enable loopback detection on an interface and set the action to block.

    When a loop is detected, the device blocks the interface and forwards only BPDUs.

    Enable (Shut Down Interface)

    Enable loopback detection on an interface and set the action to shutdown.

    When a loop is detected, the device shuts down the interface.

    Disable

    Disable loopback detection on the interface.

  2. Select an interface that you want to configure.

    Perform either of the following operations:

    • Click the interface icon to select one or more interfaces.
    • Drag the mouse to select consecutive interfaces in a batch.
    • Select an LPU and all interfaces on the LPU.

  3. Click Enable (Block Interface) or Enable (Shut Down Interface) to enable loopback detection on an interface and set the action taken when a loop is detected.

    By default, loopback detection is disabled on an interface.

    NOTE:

    If Enable (Shut Down Interface) is selected, the interface is shut down when a loop is detected. The shutdown interface can be restarted in Interface Settings > Enable/Disable Interface. For details, see Enable/Disable Interface.

  4. Check the configuration.

    The loopback detection status is displayed on all interfaces that need to be enabled with loopback detection, as shown in Figure 5-105, the configuration is successful. Otherwise, the configuration fails.

    NOTE:

    After line loopback detection is enabled, the system detects loops after about 5s. After 5s, click to view the interface status.

    Figure 5-105  Loopback detection configuration result

Translation
Download
Updated: 2019-10-17

Document ID: EDOC1000178323

Views: 85183

Downloads: 112

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next