No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Web-based Configuration Guide

S7700 and S9700 V200R011C10

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
CSS

CSS

Context

A cluster switch system (CSS) connects two physical switches using dedicated CSS cables into a single logical switch. A CSS is also called a cluster. A single switch cannot meet requirements of increasing data access in data centers and high network reliability, while CSS can provide high forwarding performance and high network reliability. After two switches set up a CSS, one switch functions as the master switch, and the other functions as the backup switch. The S7703 and S9703 switches do not support this function.
NOTE:
In CSS card clustering, CSS ports cannot be configured.

Procedure

  1. Choose Configuration > Advanced Services > CSS in the navigation tree to open the CSS page, as shown in Figure 5-124.

    Figure 5-124  CSS configuration page

  2. Set CSS status to ON and CSS mode to CSS card clustering or Service port clustering.
  3. Click the data line below Configure CSS Members to configure Master switch or Standby switch, as shown in Figure 5-125. Set parameters and click .

    NOTE:
    Standby switch is displayed only when the switch joins a CSS.
    Figure 5-125  CSS member configuration page

  4. Click Master switch or Standby switch below Configure CSS Members to open the Configure CSS Port (Master switch) or Configure CSS Port (Standby switch) page, and click Create, as shown in Figure 5-126.

    Figure 5-126  CSS port configuration

  5. Select an appropriate logical port from the Physical Member Port Added drop-down list, click Select Interface to select CSS member ports, and click .
  6. Click Apply. In the dialog box that is displayed, click OK. Check CSS information below Display Information.
Translation
Download
Updated: 2019-10-17

Document ID: EDOC1000178323

Views: 85225

Downloads: 112

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next