No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Web-based Configuration Guide

S7700 and S9700 V200R011C10

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Trace Route

Trace Route

You can use the tracert command to test the gateways that packets pass through from the source host to the destination host. The tracert command is used to check network connectivity and locate network faults.

Context

The Tracert command, also called Trace Route, helps you check the IP addresses and the number of gateways between the source and the destination. Tracert is used to check network connectivity and locate network faults.

Procedure

  1. Choose Diagnosis > Diagnostic Tools > Trace Route to access the Trace Route page, as shown in Figure 6-4.

    Figure 6-4  Trace Route

  2. Enter the IP address in the Trace Route text box and click Start. The Layer 3 devices where packets pass through between the source host and the destination host are displayed.

    NOTE:
    • The output of the tracert command includes IP addresses of all the gateways through which the packet reaches the destination. If one gateway sends back a packet indicating TTL timeout, * is displayed.
    • The tracert test may take a long time.

Translation
Download
Updated: 2019-10-17

Document ID: EDOC1000178323

Views: 88102

Downloads: 112

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next