No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic IPv6 IS-IS Functions

Configuring Basic IPv6 IS-IS Functions

Pre-configuration Tasks

Before configuring basic IPv6 IS-IS functions, complete the following tasks:

  • Enable the IPv6 forwarding capability on the device.

  • Configure IPv6 addresses for interfaces to ensure that neighboring nodes are reachable at the network layer.

Configuration Procedure

  1. Create an IS-IS process.
  2. Configure a network entity title (NET).
  3. Configure a device level.
  4. Establish an IS-IS neighbor relationship.
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 275747

Downloads: 223

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next