No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting OSPF Route Selection

Adjusting OSPF Route Selection

Applicable Environment

To meet various requirements, such as flexible networking or load balancing optimization on complex networks, adjust OSPF parameters.

Pre-configuration Tasks

Before adjusting OSPF route selection, complete the following tasks:

Configuration Procedure

Perform one or more configuration tasks as required (the task of Verifying the OSPF Route Selection Control Configuration must be performed).

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 217585

Downloads: 194

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next