No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the IPv4 IS-IS Auto FRR Configuration

Verifying the IPv4 IS-IS Auto FRR Configuration


All IS-IS Auto FRR configurations are complete.


  • Run the display isis route [ process-id | vpn-instance vpn-instance-name ] [ ipv4 ] [ verbose | [ level-1 | level-2 ] | ip-address [ mask | mask-length ] ] * command to check information about the primary link and backup link after IS-IS Auto FRR is enabled.
  • Run the display isis spf-tree [ systemid systemid | dname dname ] [ [ level-1 | level-2 ] | ipv6 | verbose ] * [ process-id | vpn-instance vpn-instance-name ] command to check the traffic protection type of IS-IS Auto FRR.
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 273523

Downloads: 222

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next