No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic OSPFv3 Function Configuration

Verifying the Basic OSPFv3 Function Configuration


Configuring basic OSPFv3 functions is complete.


  • Run the display ospfv3 [ process-id ] command to check the summary information about the OSPFv3 process.
  • Run the display ospfv3 [ process-id ] interface [ area area-id ] [ interface-type interface-number ] command to check the OSPFv3 interface information.
  • Run the following commands to check OSPFv3 LSDB information:

    • display ospfv3 [ process-id ] lsdb [ area area-id ] [ originate-router advertising-router-id | self-originate ] [ { router | network | inter-router [ asbr-router asbr-router-id ] | { inter-prefix | nssa } [ ipv6-address prefix-length ] | link | intra-prefix | grace } [ link-state-id ] ]

    • display ospfv3 [ process-id ] lsdb [ originate-router advertising-router-id | self-originate ] external [ ipv6-address prefix-length ] [ link-state-id ]

  • Run the display ospfv3 [ process-id ] [ area area-id ] peer [ interface-type interface-number ] [ verbose ] command or display ospfv3 [ process-id ] [ area area-id ] peer neighbor-id [ verbose ] command to check the information about the OSPFv3 neighbor.
  • Run the display ospfv3 [ process-id ] routing [ abr-routes | asbr-routes | statistics [ uninstalled ] | ipv6-address prefix-length | intra-routes | inter-routes | ase-routes | nssa-routes ] command to check the OSPFv3 routing table:
  • Run the display ospfv3 [ process-id ] path command to check the paths to a destination address.
  • Run the display default-parameter ospfv3 command to check the default OSPFv3 configuration.
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 276645

Downloads: 223

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next