No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Intelligent Timer for Generating LSAs

Configuring an Intelligent Timer for Generating LSAs

Context

Setting a millisecond-level interval for generating the same LSA speeds up network convergence. If a network becomes unstable, configure an intelligent timer to reduce the interval.

Perform the following operations on the switch that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run lsa-originate-interval intelligent-timer max-interval start-interval hold-interval

    An SPF intelligent timer is set for updating OSPFv3 LSAs.

    • max-interval specifies the maximum interval for updating LSAs. The value ranges from 1 to 10000, in milliseconds.
    • start-interval specifies the initial interval for updating LSAs. The value ranges from 0 to 1000, in milliseconds.
    • hold-interval specifies the hold interval for updating LSAs. The value ranges from 1 to 5000, in milliseconds.

    By default, the maximum interval for updating LSAs is 5000 ms, the initial interval for updating LSAs is 500 ms, the hold interval for updating LSAs is 1000 ms.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 204847

Downloads: 178

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next