No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the OSPF IP FRR Configuration

Verifying the OSPF IP FRR Configuration


All OSPF IP FRR configurations have been configured.


  • Run the display ospf [ process-id ] routing command to check information about the primary and backup links after OSPF IP FRR is enabled.

    View the routes to the specified OSPF device.

    <HUAWEI> display ospf routing
             OSPF Process 1 with Router ID
     Destination :     
     AdverRouter :                 Area      :  
     Cost        : 2                        Type      : Transit 
     NextHop     :              Interface : Vlanif20  
     Priority    : Low                      Age       : 00h00m10s  
     Backup Nexthop :           Backup Interface: Vlanif10
     Backup Type : LFA LINK

    The preceding display shows that a backup route is generated on switch, including information about the backup next hop: Backup NextHop is address of the backup next hop, Backup Interface is outbound interface of the backup next hop, Backup Type is type of the backup next hop.

Updated: 2020-02-04

Document ID: EDOC1000178324

Views: 286157

Downloads: 229

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next