No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
BGP Tracking

BGP Tracking

BGP tracking provides fast link fault detection to speed up network convergence. When a fault occurs on the link between BGP peers that have BGP tracking configured, BGP tracking can quickly detect peer unreachability and instruct the routing management module to notify BGP of the fault, achieving rapid network convergence.

Compared to BFD, BGP tracking is easy to configure because it needs to be configured only on the local device. BGP tracking is a fault detection mechanism at the routing layer, whereas BFD is a fault detection mechanism at the link layer. BGP route convergence on a network where BGP tracking is configured is slower than that on a network where BFD is configured. Therefore, BGP tracking is not suitable for voice services that require fast convergence.


In Figure 9-12, RouterA and RouterB, and RouterB and RouterC establish IGP connections. RouterA and RouterC establish an IBGP peer relationship. BGP tracking is configured on RouterA. When a fault occurs on the link between RouterA and RouterB, IGP performs fast convergence. Subsequently, BGP tracking detects the unreachability of the route to RouterC and notifies the fault to BGP on RouterA, which then interrupts the BGP connection with RouterC.

Figure 9-12  Networking diagram of BGP tracking


If establishing an IBGP peer relationship requires IGP routes, the interval between peer unreachability discovery and connection interruption needs to be configured. This interval must be longer than the IGP route convergence time. Otherwise, before IGP route flapping caused by transient interruption is suppressed, the BGP peer relationship may have been interrupted, causing unnecessary BGP convergence.

Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 274296

Downloads: 223

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next