No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BFD for OSPFv3

Configuring BFD for OSPFv3

Context

After enabling BFD for OSPFv3, you need to configure BFD parameters in the OSPFv3 process.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 process-id

    The OSPFv3 view is displayed.

  3. Run bfd all-interfaces { min-transmit-interval min-transmit-value | min-receive-interval min-receive-value | detect-multiplier detect-multiplier-value }*

    OSPFv3 BFD parameters are configured.

    Using the default min-transmit-value, min-receive-value, and detect-multiplier values is recommended. Therefore, the ospfv3 bfd { min-transmit-interval min-transmit-value | min-receive-interval min-receive-value | detect-multiplier detect-multiplier-value }* [ instance instance-id ] } command can be skipped.

    The parameters are configured based on the network status and network reliability requirements. A short interval at which BFD packets are transmitted can be configured for a link that has a higher requirement for reliability. A long interval at which BFD packets are transmitted can be configured for a link that has a lower requirement for reliability.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 207849

Downloads: 178

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next