No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic OSPF Functions

Configuring Basic OSPF Functions

Applicable Environment

When OSPF is configured on multiple switches in the same area, most configuration data, such as the timer, filter, and aggregation, must be planned uniformly in the area. Incorrect configurations may prevent neighboring switches from exchanging messages or even cause routing information congestion and self-loops.

OSPF configurations performed in interface views take effect regardless of whether OSPF is enabled. These configurations remain in place even if OSPF is disabled.

Pre-configuration Tasks

Before configuring basic OSPF functions, configure IP addresses for interfaces to ensure that neighboring nodes are reachable at the network layer.

Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 274303

Downloads: 223

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next