No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting a Convergence Priority for OSPF Routes

Setting a Convergence Priority for OSPF Routes


A network may bear many different services, such as data, voice, and video. These services have different requirements for the network. For Video on Demand (VoD) services, the route convergence speed of a multicast source server affects multicast services most. As such, the routes to the multicast source must converge rapidly if network faults occur. On a BGP or MPLS VPN bearer network where OSPF is used to implement IP connectivity of the backbone network, end-to-end routes between PEs must be converged rapidly.

To ensure that OSPF routes converge preferentially, configure priorities for these routes. This shortens the interruption of key services and improves the reliability of the entire network.


  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF view is displayed.

  3. Run prefix-priority { critical | high | medium } ip-prefix ip-prefix-name

    A convergence priority is set for OSPF routes.

    OSPF then calculates and floods LSAs and synchronizes LSDBs according to the priority. This speeds up route convergence. When an LSA meets multiple priorities, the highest priority takes effect. OSPF calculates LSAs in the sequence of intra-area routes, inter-area routes, and AS external routes. This command forces OSPF to calculate route priorities. Convergence priorities are critical, high, medium, and low. During LSA flooding, LSAs are placed into the corresponding critical, high, medium, and low queues according to priorities, which speeds up the processing of high-priority LSAs.


    This command takes effect only on the public network.

Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 274319

Downloads: 223

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next