Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting a Priority for OSPF Routes
Context
A priority can be set for each routing protocol that a switch runs. When these protocols discover the same route, the route discovered by the highest-priority routing protocol takes effect.
Procedure
- Run system-view
The system view is displayed.
- Run ospf [ process-id ]
The OSPF process view is displayed.
- Run preference [ ase ] { preference | route-policy route-policy-name } *
A priority is set for OSPF routes.
- The parameter ase specifies a priority for AS external routes.
- The parameter preference specifies the priority of OSPF routes. A smaller value indicates a higher priority.
- The parameter route-policy route-policy-name specifies a priority for specified routes according to the routing policy.
The default priority of OSPF routes is 10. When the parameter ase is specified, the default priority of AS external routes is 150.
Previous
