No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic OSPFv3 Functions

Configuring Basic OSPFv3 Functions

Applicable Environment

Configure basic OSPFv3 functions before building OSPFv3 networks. Enable OSPFv3 and specify the interface, area ID, and router ID before configuring other functions.

Pre-configuration Tasks

Before configuring basic OSPFv3 functions, complete the following tasks:

  • Enable IPv6 capabilities.

  • Make the network layers of the adjacent nodes accessible.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 224827

Downloads: 195

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next