No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPFv3 Virtual Links

Configuring OSPFv3 Virtual Links

Context

After an OSPFv3 area is defined, OSPFv3 route updates between non-backbone areas are implemented through a backbone area. OSPFv3 requires all non-backbone areas to maintain connectivity with the backbone area and the backbone area to maintain its own connectivity as well. If this requirement cannot be met, configure OSPFv3 virtual links.

A virtual link must be configured at both ends of the link, or it will not take effect.

Perform the following operations on the switch that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run area area-id

    The OSPFv3 area view is displayed.

  4. Run vlink-peer router-id [ hello hello-interval | retransmit retransmit-interval | trans-delay trans-delay-interval | dead dead-interval | instance instance-id | { authentication-mode { hmac-sha256 key-id key-id { plain plain-text | [ cipher ] cipher-text } | keychain keychain-name } | ipsec sa sa-name } ] *

    A virtual link is created and configured.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 204575

Downloads: 178

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next