No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling RIP on the Specified Network Segment

Enabling RIP on the Specified Network Segment

Context

After enabling RIP, specify the network segment where RIP runs. RIP runs only on the interfaces that reside on the specified network segment. RIP does not receive, send, or forward routes on the interfaces that do not reside on the specified network segment.

Procedure

  • Enable RIP to send and receive routes on the specified network segment.
    1. Run system-view

      The system view is displayed.

    2. Run rip [ process-id ]

      The RIP view is displayed.

    3. (Optional) Run undo verify-source

      Source check is disabled for RIP packets.

      If IP addresses of devices on both ends of a P2P link belong to different network segments, the two devices cannot establish a neighbor relationship unless source check is disabled.

    4. Run network network-address

      RIP is enabled on the specified network segment.

      NOTE:
      • network-address specifies the address of a natural network segment.
      • An interface can be associated with only one RIP process.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 234071

Downloads: 203

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next