No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LSP Fragment Extension

Configuring LSP Fragment Extension

Pre-configuration Tasks

Before configuring LSP fragment extension, create IS-IS processes.

NOTE:

When a new device connects to an IS-IS network, you are advised to configure LSP fragment extension and virtual systems before establishing IS-IS neighbors or importing routes. If you establish IS-IS neighbors or import routes without configuring LSP fragment extension and virtual systems, IS-IS needs to carry much information, which cannot be loaded through 256 fragments. You must then configure LSP fragment extension and virtual systems, which will take effect only after you restart the IS-IS process.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    The IS-IS view is displayed.

  3. Run lsp-fragments-extend [ [ level-1 | level-2 | level-1-2 ] | [ mode-1 | mode-2 ] ] *

    LSP fragment extension is enabled in an IS-IS process.

    By default, LSP fragment extension is disabled in an IS-IS process.

    If the mode or level is not specified during the configuration of LSP fragment extension, mode-1 and level-1-2 are used by default.

    NOTE:

    If there are devices of other manufacturers on the network, LSP fragment extension must be set to mode-1. Otherwise, devices of other manufacturers cannot identify LSPs.

  4. Run virtual-system virtual-system-id

    A virtual system is configured.

    By default, no virtual system is configured.

    To configure a switch to generate extended LSP fragments, you must configure at least one virtual system. The ID of the virtual system must be unique in the domain.

    An IS-IS process can be configured with up to 50 virtual system IDs.

Verifying the Configuration

Run the following commands to check IS-IS process statistics.

  • display isis statistics [ updated-lsp [ history ] ] [ level-1 | level-2 | level-1-2 ] [ process-id | vpn-instance vpn-instance-name ]
  • display isis process-id statistics [ [ [ updated-lsp [ history ] ] [ level-1 | level-2 | level-1-2 ] ] | [ packet ] ]
Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178324

Views: 235500

Downloads: 205

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next