No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IS-IS Route Summarization

Configuring IS-IS Route Summarization

Pre-configuration Tasks

Before configuring IS-IS route summarization, complete the following task:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    The IS-IS view is displayed.

  3. Run summary ip-address mask [ avoid-feedback | generate_null0_route | tag tag | [ level-1 | level-1-2 | level-2 ] ] *

    The specified IS-IS routes are summarized into one IS-IS route.

    NOTE:

    After route summarization is configured on a device, the local routing table still contains all specific routes before the summarization. The routing tables on other devices contain only the summary route, and the summary route is deleted only after all its specific routes are deleted.

Verifying the Configuration

  • Run the display isis route command to check summary routes in the IS-IS routing table.

  • Run the display ip routing-table [ verbose ] command to check summary routes in the IP routing table.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 223029

Downloads: 194

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next