No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Equal-Cost IPv6 IS-IS Routes

Configuring Equal-Cost IPv6 IS-IS Routes

Context

If there are redundant IS-IS links, multiple routes may have an equal cost.

Configure load balancing among equal-cost IS-IS routes so that traffic will be evenly balanced among these links. This mechanism increases the link bandwidth usage and prevents network congestion caused by link overload. However, this mechanism may make traffic management more difficult because traffic will be randomly forwarded.

Procedure

  • Configure load balancing among equal-cost IS-IS routes.
    1. Run system-view

      The system view is displayed.

    2. Run isis [ process-id ]

      The IS-IS view is displayed.

    3. Run ipv6 maximum load-balancing number

      The maximum number of equal-cost IPv6 IS-IS routes for load-balancing is set.

      By default, load balancing is supported and a maximum of 16 equal-cost routes can participate in load balancing.

      NOTE:
      When the number of equal-cost routes is greater than number specified in the ipv6 maximum load-balancing command, valid routes are selected for load balancing based on the following criteria:
      1. Route preference: Routes with higher preferences are selected for load balancing.
      2. Next hop system ID: If routes have the same priorities, routes with smaller system IDs are selected for load balancing.
      3. Interface index: If routes have the same priorities and system IDs, routes with lower interface index values are selected for load balancing.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178324

Views: 204545

Downloads: 178

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next